Standard Components For Plastic Mold 2021

INFORMATION ON NEW PRODUCTS

STRAIGHT EJECTOR PINS

GAS VENT COMPONENTS

SLIDE CORE / LOOSE CORE

COMPONENTS FOR EJECTOR SPACE

MOLD OPENING CONTROLLERS

D P.436

D P.623

D P.897/898

D P.929/930

D P.33/34

D P.53/54

Front Two–step Ejector Unit Rear Two–step Ejector Unit 2 type two-step ejection. The amount of ejection can be freely adjusted. Also functions as Ejector Leader Pins / Bushings.

Internal Latch Lock Mold opening is controlled within the mold.

Sprung Cores Inclined Pins is not required. Undercut processing is possible with this product alone. Processing time is also greatly reduced.

Porous Vent ® Block Type MISUMI’s original porous metal block material. Gas is released from the entire surface of the molded product, enabling processing of a variety of shapes.

Stepped Ejector Pins for Die Cast Newly released Ejector Pins for die-casting molds with shaft diameter tolerance of –0.02/–0.04 For full-length cutting.

Dies Ejector Pin With Gas Vent Gas venting function added to die material Ejector Pins. Flat cut and headband types are available.

The amount of mold opening can be freely adjusted. Used for small and medium–sized molds with no space outside the mold.

CHEMICAL PRODUCTS / COMPONENTS FOR INJECTION MOLDING

COOLING COMPONENTS ②

GAS VENT COMPONENTS

ACCESSORIES

D P.437

D P.440

D P.455/456

D P.1036

D P.1123–1126

D P.1133

Porous Vent ® Round Type Porous metal round material. Blank type that can be machined and relief hole type that can be effortlessly installed are available.

Ejector Pins with Gas Vent Filter Ejector Pins with a gas releasing filter press-fitted into the tip. Applicable to shaped products and large products also.

Cooling Circuit Plugs –Heat resistant 150°C– High temperature type for Cooling Circuit Plugs. The Plugs that is fixed to the cooling hole and allows free setting of the cooling water circulation path.

High Performance Swivel Lifting Eye Bolts Five times higher safety factor/high durability. Can be rotated even under load. Passed 20,000 cycles of use test with maximum 1.5 times allowance load.

Insert Blocks with Slit Vent (Slit width 30μm) Slit structure provides high gas release effect. A new type that retains gas release performance even after processing is now available.

Lubricant (Heat–Resistant Grease) Heat resistance of 426°C. Adhesive, retains viscosity even at high temperatures.

CHEMICAL PRODUCTS / COMPONENTS FOR INJECTION MOLDING

GAS VENT COMPONENTS

SLIDE CORE / LOOSE CORE

D P.457/458

D P.578

D P.608

D P.1133

Core Pins with Gas Vent Filter Core Pins with a gas releasing filter press-fitted into the tip. Powerful filter with great gas release effect.

Oil-free Slide units for Loose Core –Assist Rod– Allows for steeper undercut tilt angles.

Micro Slide Core Unit More compact Mini Slide Core Unit. Stroke can be selected from 3mm or 6mm type.

Lubricant (Extra Heat–Resis- tant Grease) Heat resistance up to 800°C.

Detergent (Zap–Ox) New all-purpose cleaner. Removes dirt and rust from metal surfaces. Can be used for antioxidant, etc.

Sealant (Slic tite) New sealing agents are now available in chemical products. Non-drying, easy cleaning possible.

E Some products are only available in Japan or in some countries/regions.

Introduction- 1

Introduction- 2